URC7115, URC7125, URC7145: How do I perform a factory reset on my Evolve remote?

Before resetting the Evolve, please take the following into account:
If you have ever sent in your remote control to our Upgrade Service for an update, these codes will be erased as well. In that case, it is highly advised not to perform a factory reset.

To reset your remote to the manufacturer's setting, please follow the procedure outlined below:

  1. Remove a battery from the remote and press a button with it removed
  2. Reinsert the battery – the LED should blink twice
  3. Press the digits 2 and 8 simultaneously within 6 seconds – the LED should blink twice and stays on.
  4. Enter the code 9 8 1, the LED will blink 4 times
  5. The remote is now reset to its factory defaults. 
You can now setup your remote again.

N.B. The procedure must be performed within 6 seconds of applying power to the remote, that is, inserting batteries. After 6 seconds of Power it will not activate.