URC1920: How do I program my code on my Freeview Replacement Remote?

To program the basic code on your Freeview Replacement remote, please follow the instructions mentioned below:

1. Press the relevant device key.
2. Hold down SETUP until the light blinks once and then twice and stays on.
3. Enter the code, the light will blink twice.
4. You can now operate your device.

If the LED does not blink twice at the end, please try the following:

1. Hold down SETUP until the light blinks once and then twice and stays on.
2. Enter 992, the light will blink twice.
3. Press the device key twice, the light will blink twice.
4. You can now set up the device code.