URC7120, URC7130, URC7140: How do I program my code on my Essence remote?

To program the basic code on your Essence remote, please follow the instructions mentioned below:

1. Hold down MAGIC until the light blinks once and then twice and stays on.
2. Press the MODE key to select the relevant device key.
3. Enter the code, the light will blink twice.
4. You can now operate your device.

If the LED does not blink twice at the end, please try the following

1. Hold down MAGIC until the light blinks once and then twice and stays on.
2. Press the MODE key to select the relevant device key.
3. Enter 992, the light will blink twice.
4. Press the Magic key once, the light blinks once.
5. Press the Magic key again, the light will blink twice.
6. You can now set up the device code.