URC7115: How do I program my code on my Evolve remote?

To program the basic code on your Evolve remote, please follow the instructions mentioned below:

  1. Hold down MAGIC until the light blinks once and then twice and stays on.
  2. Enter the code, the light will blink twice.
  3. You can now operate your device.

If the LED does not blink twice at the end, please try the following

  1. Hold down MAGIC until the light blinks once and then twice and stays on.
  2. Enter 992, the light will blink twice.
  3. Press the Magic key once, the light blinks once.
  4. Press the Magic key again, the light will blink twice.
  5. You can now set up the device code.